Electronics > Beginners

Modern oscilloscope views: YT, XY but where is XYZ ?

<< < (5/6) > >>

stj:
yes, i asked because you dont really see the screen refresh rates mentioned with reasonable priced scopes like Rigol, Siglent or GW-Instek.

Ivan7enych:
Sorry, I raise up this old thread.

I just found undocumented XYZ mode in my Agilent MSOX3000!

This oscilloscope has XY mode and locks X to channel 1 and Y to channel 2, but if you put any signal to Trigger Input - it will work as bynary Z input! I've found this accidentally, wondering why I see only half of XY picture, when signal generator Trigger Out was connected to oscilloscope Trigger In.

Here it is seen in my video (in russian). 
0:40 - I disconnect Trigger Input and half picture become full picture.
1:15 - I connect 3rd generator to Trigger Input


mikeselectricstuff:
What would be interesting is a scope that would do XYZ plotted as a 3D image, with the scope controls adjusting the viewpoint.

Yansi:
Meow!

MarkL:

--- Quote from: Ivan7enych on October 25, 2019, 11:26:52 am ---...
I just found undocumented XYZ mode in my Agilent MSOX3000!

--- End quote ---
Actually, it is in the user manual.  It's called "blanking" and has a fixed on/off threshold of 1.4V.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod