Electronics > Beginners
Motor controller help!
ManlishPotato:
To answer your questions:
It does not crash without the motor connected.
The voltages are created via the two channels of my lab power supply.
Vcc and GND are supplied via each pin like in the schematic, i have tested all the connections and they are solid.
With that said i finally made it work with the help of Psi! The solution was smoothing capacitors and 1k resistors pulling the input to gnd.
ManlishPotato:
Yaaaaaas! Finally got it working!
Thanks to Manx and especially Psi for helping me! :-+ :-+
Here is a video of it working:
https://drive.google.com/file/d/103jWOH9mpPur37N9i3-5pMfdRGwpzIQK/view?usp=sharing
Manx:
Congrats! :)
Navigation
[0] Message Index
[*] Previous page
Go to full version