Author Topic: Moving up from proto boards  (Read 1687 times)

0 Members and 1 Guest are viewing this topic.

Offline chandin

  • Contributor
  • Posts: 15
Moving up from proto boards
« on: April 25, 2011, 10:10:25 am »
So I was wondering say you have your idea working fine on an arduino or mbed or whatever. What are the next steps to make a self contained board for your project. I looked in google but did not find anything promising.
Is there an episode about this?, If not it would be a good idea.
But till then please enlighten me on this thread
 

Offline Psi

  • Super Contributor
  • ***
  • Posts: 7526
  • Country: nz
Re: Moving up from proto boards
« Reply #1 on: April 25, 2011, 10:18:08 am »
You pretty much just duplicate the parts of the arduino board circuit diagram, that your project uses, onto your own pcb design.
Adding in any external components you attached to the arduino.
Greek letter 'Psi' (not Pounds per Square Inch)
 


Share me

Digg  Facebook  SlashDot  Delicious  Technorati  Twitter  Google  Yahoo
Smf