Electronics > Beginners
Multimeter Vichy VC97 - measuring resistance
(1/4) > >>
nForce:
Hello, I have this multimeter, and when I am trying to measure resistance below 1 ohm, I don't get any reading. I was looking at the manual, and I don't see that it can measure resistance below 1 ohm. So it actually can't? Does anyone have this multimeter?

Thanks.
joseph nicholas:
Mine says .6 ohms when I short the test leads.  What does your meter call out when doing this?
MosherIV:
Most hand held dmm are no good below 1 \$\Omega\$.
Even the best like Fluke87V will not give very acurate readings.
nForce:

--- Quote from: joseph nicholas on September 08, 2019, 05:48:55 pm ---Mine says .6 ohms when I short the test leads.  What does your meter call out when doing this?

--- End quote ---

Try to measure 0.27 Ohm resistor. I get value 0.2 or 0.3. What now?
MosherIV:
Can you set up 100mA cinstant current?
If so, put the resistor across it and measure the resulting voltage on the resistor.  :-/O
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod