Electronics > Beginners
Need a latching buffer, need help configuring
<< < (3/3)
fsr:
Well, if that's the case, then raise the resistor value, but keep connections short and low impedance, because at some point, noise could be an issue. Also it will turn slower with higher resistance values, so check to see if that becomes an issue.
jnz:
Tested it just now... Turns out it's 4V and approx 250k. So not 'just' an internal pullup, but effectively.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod