Need help identify the component on this PCB.

[BeBuLamar]

I get this PCB to make use of the Avago APDS-9007 as I can't attach wires o the sensor without a PCB. The PCB convert the current output to volltage which is OK but would like to identfy the components on the PCB.

[jwet]

That is the ADPS-9007 light sensor if I'm seeing things correctly.  It puts out current and the PCB converts to volts like you thought.  Transimpedance amp.

Am I missing something- are you pointing at something else?  (Also, Broadcom bought this product line and most others from Avago- formerly HP )

[BeBuLamar]

I know the Avago sensor but what are the other compoents. I try to find out the output impedance of the circuit.

[jwet]

Your red circle threw me off. Your picture doesn't have enough resolution to read the back marks or part nos. on the IC's.  Ring it out a bit and maybe draw at least a partial schematic- it will start to make sense.  Its most likely a linear regulator IC and an OP_AMP.  if you can zoom in a bit and get some connectivity/netlist and backmarks, it would help a lot.  That sensor makes a current, you feed its output to a resistor to convert to volts but better a low voltage referenced transimpedance amp.  The output impedance will be quite low- <500 ohm depending on whether they put a resistor in series to make it more rugged for hobbyists.  Ring it out.

[BeBuLamar]

Perhaps this is a little bit better

[Jwillis]

jwet is correct. It's a  BROADCOM APDS-9007-020

[BeBuLamar]

I need to identify the other components not the light sensor.

[ArdWar]

What do you even need to identify here? The one with 33 marking is obviously a 3v3 regulator, and one with OA marking is an opamp. Both use common standard pinout and I don't think the exact part number matter that much here (within reason). The only thing remotely critical here is the 51k current shunt.