Electronics > Beginners

No-solder no-crimp wire-to-wire connectors for 32 AWG wires?

<< < (4/4)

Kjelt:
Ok got a possibility here, not the most robust but it will do.
Connect the wire from the powersupply or batteries across the female pcb connector strips that you cut to the desired nr of contacts. Isolate with tape.
Then the male you break off one by one and wirewrap and solder the wire.
You could add one or double heat shrink tubing (preferably with hotglue inside) to mechanically secure it but that AWG32 wire is quite brittle.

You can get those connectors in a lot of colours to fit your Lego.
https://nl.aliexpress.com/item/4000158960546.html

Navigation

[0] Message Index

[*] Previous page