Electronics > Beginners
OP Amp Question
(1/2) > >>
Jwillis:
I'm trying to wrap my head around the data sheet and other stuff about Op Amps but was never any good at understanding what I'm reading.
https://www.ti.com/lit/ds/symlink/opa445.pdf

Now as I under stand from the data sheet the Common-Mode Voltage Range  or Vcm is ±5 of  ±Vss  (source voltage ).So that means that the maximum input voltage on the noniverting side would be the positive voltage source minus 5 V and the inverting side would be the the negative voltage source plus 5 volts ?
So for example in my diagram the positive voltage source is 35V so the positive input would be 30V maximum and on the negative side at -10V would be -5V minimum inputs on both inverting and non inverting relative to a zero V common ground.
Is that correct ?
xavier60:
"Common Mode" implies that the same voltage is applied to both inputs simultaneously.
The specs don't make complete sense to me. They say -35V to +35V for a supply voltage of +/-40V which is range of 70V.
So I don't understand what the "80" and "95" are supposed to mean.


















 
Jwillis:
I'm still learning but what I'm trying to figure out is the maximum voltages to the inputs as related to the supplied voltages relative to a common ground.
bson:
Neither input can stray outside the common-mode voltage range.  So if the supplies are ±25V the inputs need to stay between ±20V.  Both of them.
Jwillis:

--- Quote from: bson on May 09, 2019, 03:28:57 am ---Neither input can stray outside the common-mode voltage range.  So if the supplies are ±25V the inputs need to stay between ±20V.  Both of them.


--- End quote ---

OK but on page 8 of the data sheet under power supplies it states that the positive supply can be 80V and the negative supply can be -10v or visa-versa That means to me that the total voltage across both the positive supply and negative supply can't exceed 90V and and is not less than 20V total.So neither supply needs to be equal provided that the maximum and minimum voltage ratings arn't exceeded.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod