Electronics > Beginners
OP Schematic Voltage to Current Converting ExpLog
(1/2) > >>
richi:
Hi,

i want to make Voltage to Current converting, but not linear, i need it ExpLog.

0-5V is the Control Voltage for Input to the OPV.
Output is like an LED with breakdown voltage 2-4V and its have a treshold current, example 50-200mA
Now i want the 0-5V translate it to "treshold current" -> 1A
If 0V then treshold current goes to 0mA and if  0,1V then start treshold Current and makes it exponetial function to the max values.

Any idea ?

Signal32:
I assume you didn't nt want to go the door gital route ? ADC + Micro + DAC ? Then you can do whatever you want with conversion.
richi:
Hi Signal32,

I would like to implement the purely analog, otherwise there would be time delays, and i need it up to 100kHz.
analog digital would certainly be a fine solution, but the effort would be too big, because I need the whole at least 3 times
MasterT:
Can't see a point to have 100kHz (10 usec) response time for LED.  Visual perception by human being is more than 40 milliseconds, AFAIK, though 25 Hz should be sufficient.
richi:
it's not about the LED and the viewing with the eye. I'm only interested in the analog circuit with operational amplifiers.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod