Electronics > Beginners

OTC "Silasitc"?

<< < (4/9) > >>

coppercone2:
half your time? really? are you refining your own aluminum or something?

get real. Are you drilling the holes with a sharp stick or are you trying to cut metal with a butter knife here?

absolutely preposterous.

wraper:

--- Quote from: coppercone2 on February 04, 2019, 09:04:34 pm ---half your time? really? are you refining your own aluminum or something?

get real

--- End quote ---
Feels like logic falling apart when written by you. IMO you should look in the mirror.

coppercone2:
your telling my its going to take long to drill a few holes and bend a piece of metal ???

yea half my time
quarter of a cigarette break?

wraper:

--- Quote from: coppercone2 on February 04, 2019, 09:11:29 pm ---your telling my its going to take long to drill a few holes and bend a piece of metal ???

yea half my time
quarter of a cigarette break?

--- End quote ---
You could solder a whole pcb faster than bending that stupid metal and drilling holes. Also you need to spend a lot of time when designing PCB just to make that those fixtures would fit. Insanity squared  :palm:. Please show an example of actual PCB with this stupid crap.

coppercone2:

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod