Electronics > Beginners
Over voltage protection and reverse polarity protection
(1/2) > >>
roogadget:
My specs are 9V - 15V.

My project requires Over voltage protection and reverse polarity protection.

What is the "best" way to do this for a simple project?

Do I design a circuit to check for this or do i just go with a chip that handles it??
JPortici:
PTCC + TVS may be a very simple solution, need more information
T3sl4co1l:
Nominal load 1mA or 1kA?

Overvoltage of 16V or 16kV?

Reverse of -1V or -1kV?

Is it a slow swell, fast transient, lightning surge, nuclear EMP?

Once you know the voltage, current and time scales of the system, methods become apparent. :)

Tim
Neilm:
Is this a personal project, or does it have a commercial application? If the latter, does it have to meet any standards, for instance automotive standards?
Brumby:
As above ... More information needed.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod