Electronics > Beginners
Planet CNC controller and software
(1/1)
sairfan1:
Hello friends, I bought Chinese CNC mini machine that came with fake Planet CNC card installed and software does not work, This machine accepts both kind of inputs, Parallel Cable and USB. I decided to buy Planet CNC MK3 Controller and software License.

But before taking further step i just want to get some feedback/opinion from you guys if you think Planet CNC MK3 is a good controller and easy to install/configure etc. being a hobbyist i do not have enough time to setup complicated things, it looks me like installation is very state forward as i have to connect parallel ports.  I'm also posting picture of my CNC mini and its Parallel Port based stepper motor driver.

My major objective is PCB milling and some time cutting, I'm also concerned about how good it can engrave.
sairfan1:
looks like no body ever used planet cnc controllers??
CM800:

--- Quote from: sairfan1 on May 02, 2018, 03:35:01 pm ---looks like no body ever used planet cnc controllers??

--- End quote ---

Observant.

Considering the topic, maybe a better place to ask these questions, would be cnczone or another CNC focused forum?
sairfan1:
good idea, in past i saw some posts at this forum and i tought will get some feedback, but you are right should look at some other cnc related forums.

thanks
metrologist:
I'm not familiar with that system. I built my system using an inexpensive parallel port controller and Mach3.

I have since read that these are highly regarded: http://www.centroidcnc.com/centroid_diy/acorn_cnc_controller.html

I was looking at the pro version for extra axis. It looks like a complete system with hardware controller and control software.
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod