Electronics > Beginners
Programming Help for EPROM Chip
(1/2) > >>
onyx:
Hello EEVblog,

I have this EPROM chip (M27C2001-12C1 Datasheet) along with this programmer I purchased from eBay; I haven't had any success in getting the FlashCat USB software to recognize my chip. I believe the problem is that the FlashCat only supports up to 5V and the programming voltage of my chip is 12V. Does anyone know of a USB programmer and software that is compatible with my chip. I appreciate any kind of information/help I can get.

:D Thanks! :D
Cliff Matthews:
I didn't see that 27c device listed on the supported device list.. mfg says it's open to questions about other devices..
http://www.embeddedcomputers.net/contact/
onyx:
I will probably return the programmer I ordered as it only supports up to 5V and the programming voltage of my chip is over 12V. Although I have emailed the mfg of the programmer for more help.
Cliff Matthews:
Ask them and maybe they support some off-board charge pump to give you the gated 12.25v. Can't hurt.
onyx:
Got a reply back and they did not have a 12V programmer, they did refer me to a compatible chip but that was 5V. My main board supplies 12V so changing the chip wouldn't work.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod