Electronics > Beginners

Question about using a Meanwell psu with buck regulators.

(1/1)

IY3775:
Hi, with a 48V 8.4A meanwell psu (EPP-400), will I be able to draw 15-20A @12V with a buck converter like DPS 5020 or similar?

EPP-400-48 datasheet: https://www.meanwell.com/webapp/product/search.aspx?prod=EPP-400&mws=3373F963E7D2D4F7#1

Sent from my Mi A1 using Tapatalk

Gregg:
You should be OK
The Meanwell EPP 400 is capable of 400 watts (on paper).  From experience with cheap Chinese electronic modules, I usually de rate them 50%; however Meanwell is well established as a reliable supplier and assuming you have a genuine Meanwell power supply you can probably get 75% of the 400 watts from in continuously with peaks of the full 400 watts for a few minutes at a time.  Cooling is the big issue with pushing the limits of either the power source or the DPS.
The DPS 5020 is rated for 1000 watts and I definitely would de rate it 50% for long term loads but even so you are not pushing it with the EPP 400.  In any case, I would not leave the setup unattended and keep an eye out for hot spots.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod