Electronics > Beginners

repairing crt tv, start with recapping

<< < (10/11) > >>

2takt:
i dont want to get near the 31kv when its on, so the upsite i wouldnt do. i will check it tomorow if the cables are long enough for rotating 90° but your suggestion is great! i think i go with yours.

negative i can get from the shielding? the neckboard has a black ground cable that goes the shielding of the mainboard

Gyro:

--- Quote from: 2takt on September 13, 2019, 08:28:30 pm ---negative i can get from the shielding? the neckboard has a black ground cable that goes the shielding of the mainboard

--- End quote ---

Probably (without tracing it out). If measuring at CP54, you can simply measure across the capacitor - or at least continuity check between CP54 negative and the shielding first.

2takt:
ok i will update the result tomorow

2takt:
i got 148.3 v on start up and it goes up to 148,5. this should be good?
i do a longer testrun right now.

2takt:
still on 148,5v

i added a pic so you can see its just a little off

the first line is displaying green red and black flickering. it disappears when i zoom in.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod