Electronics > Beginners
Replace IR with wire
firstcolle:
intresting solution!!! let me think about that!!!
soldar:
The receiver already demodulates the IR carrier and the output is quite low frequency.
I added a three pin DIN connector to the back of the receiver box.
soldar:
This is the remote IR receiver taken from some discarded unit. The three wires at the top carry the signal. The four at the bottom go nowhere, just left over from the original unit.
ogden:
--- Quote from: soldar on September 20, 2019, 08:49:21 am ---The main problem I have is that the remote is always in the other room.
--- End quote ---
There's easy solution as well - get universal or programmable remote or DIY it yourself (retrofit old remote with MCU of your choice).
firstcolle:
i have tan TSOP34836 at home.. i can try to connect to RC-5 socket and see if it work. i miss only the 5V but i can use an external source for now..
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version