Electronics > Beginners
Replace IR with wire
<< < (5/5)
soldar:
Note that they include the demodulator and the frequencies must match.

Also, that one in particular includes a pull-up resistor. I seem mine did not and the resistor was external so several open collector detectors could be connected in parallel. It may be that even with two pull up resistors in parallel it will work.

You just need to be aware of these things. I did mine many years ago and do not remember the details.
firstcolle:
yes, both are36khz and by watching the datasheet they seem quite similar
soldar:

--- Quote from: firstcolle on September 20, 2019, 10:09:33 am --- i have tan TSOP34836 at home.. i can try to connect to RC-5 socket and see if it work. i miss only the 5V but i can use an external source for now..
--- End quote ---

What 5V? Just wire the three pins in parallel. Vcc to Vcc, out to out, gnd to gnd, dust to dust, ashes to ashes, etc.

BTW my Vcc was 3 V, not 5V.

JustMeHere:
Look for something that uses radio and converts it to IR signals.  This is how large sports bars control their TV systems.
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod