| Electronics > Beginners |
| Review 2 layer Digital only PCB design in KiCad 5.1 |
| (1/4) > >> |
| lukasz.kostka:
Hi. I'd like to learn how to design PCB boards. I've decided to go for something simple and designed a LCD controller. My goal is to make myself familliar with PCB design and ordering boards. I'd like to ask someone to review my board design. I've went with a 2 layer board with GND plane on back. My repository with files. Fab house specs from where I will order boards from. I am asking for a review of how I've placed traces, GND plane, vias. I've already checked with my fab house specs and all is fine. |
| MarkF:
You will get better responses if you post pictures of each layer for those who do NOT use KiCAD. |
| lukasz.kostka:
I've attached screenshots. |
| LaserTazerPhaser:
You can shorten traces with free angle traces instead of typical 90/45 degree traces. Traces can be a wider to match TQFP pads. |
| TheHolyHorse:
--- Quote from: LaserTazerPhaser on October 15, 2019, 02:37:01 am ---You can shorten traces with free angle traces instead of typical 90/45 degree traces. Traces can be a wider to match TQFP pads. --- End quote --- Not using 45 degree angles will make some flip :-DD But electrically it doesn't matter. |
| Navigation |
| Message Index |
| Next page |