Electronics > Beginners

Review 2 layer Digital only PCB design in KiCad 5.1

(1/4) > >>

lukasz.kostka:
Hi.

I'd like to learn how to design PCB boards. I've decided to go for something simple and designed a LCD controller. My goal is to make myself familliar with PCB design and ordering boards. I'd like to ask someone to review my board design. I've went with a 2 layer board with GND plane on back.
My repository with files.
Fab house specs from where I will order boards from.

I am asking for a review of how I've placed traces, GND plane, vias. I've already checked with my fab house specs and all is fine.

MarkF:
You will get better responses if you post pictures of each layer for those who do NOT use KiCAD.

lukasz.kostka:
I've attached screenshots.

LaserTazerPhaser:
You can shorten traces with free angle traces instead of typical 90/45 degree traces. Traces can be a wider to match TQFP pads.

TheHolyHorse:

--- Quote from: LaserTazerPhaser on October 15, 2019, 02:37:01 am ---You can shorten traces with free angle traces instead of typical 90/45 degree traces. Traces can be a wider to match TQFP pads.

--- End quote ---

Not using 45 degree angles will make some flip :-DD But electrically it doesn't matter.

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod