Electronics > Beginners
Rigol DS1054Z 50 ohm setting.
(1/3) > >>
kuifje:
Hello,

I just got the Rigol DS1054z and I can't find the 50 ohm input setting.
Normally on digital oscilloscopes you can select load resistance. Why not on this one?
Already looked in the datasheet but can't find anything.

Thanks!
0xdeadbeef:
There is none ... just like on many entry level scopes. If you need a 50Ohm input, use a 50 ohm feedthrough terminator.
ataradov:

--- Quote from: kuifje on February 14, 2019, 07:49:12 pm ---Uh... that sucks, because they didn't deliver the 50 ohm feedback terminator.

--- End quote ---
It is "feed through", and it is not included with the scope. There are plenty of options on eBay. For example https://www.ebay.com/itm/50-Ohm-Feed-Through-Terminator-BNC-to-BNC-50KY-Device-Q9-Adapter-Black/173224204575
ataradov:

--- Quote from: kuifje on February 14, 2019, 08:02:35 pm ---I'm new to this website, I have a question too about a function generator, should I make a different thread or can I just comment here?

--- End quote ---
Make a new one.
David Hess:
Oscilloscopes with bandwidths of 100 MHz and below do not usually include switchable 50 ohm terminations.  If you must, then a BNC-T and BNC 50 ohm terminator can be used at lower frequencies.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod