Electronics > Beginners

rom 23C128 TO 27C128 ADAPTER

(1/1)

Daxxin:
Any schematic about this adapter?

johnkenyon:
Might be an idea to tell us where/how you are planning to use the adaptor.

Note that the chip select/enable(s) on 23C128 were defined active high or low along with the ROM mask, and can have more than one chip select. (For example: http://hardware.speccy.org/datasheet/23c128.pdf )

One example is the ZX Spectrum - which effectively had two active low chip selects plus output enable - in this case it is better to mod the PCB to synthesise a nCE signal using a pair of diodes, and use the existing socket. (See: https://spectrumforeveryone.com/technical/fitting-eprom-48k-spectrum/).


Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod