Electronics > Beginners
RS Pro Tin 60/40 or Multicore 60/40
(1/5) > >>
Yaroooo:
Any advice between this 2?

I've tried a lot of Chinese tin, but all of them are very low quality, quite impossible to solder.

I want to buy something of good quality, maybe not the best, but good enough for non professional 8 hours continuous welding.

I've found, that I can buy at normal price from my country, this two brand. First one cost half of the second one. This price is somehow increased just for brand name Loctite? Anyone tried RS Tin?

Thanks!
CJay:
I'd be happy with the RS solder.
GreyWoolfe:
I prefer 63/37 as it is eutectic.
CJay:
In practice it makes little to no difference as long as your iron has decent heat capacity and is capable of maintaining the tip temperature but it is simpler to make good joints with eutectic solder if your technique and/or equipment is poor..

Kjelt:
Previous company had multicore solder for over 15 years, I also use it since late 90's a very good brand.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod