Electronics > Beginners
SDS1104x-e AC Coupling offset
BrianHG:
Have you done a scope self-calibration recently? Many DSOs have one buried in the utility menu somewhere.
On my old Tektronix, I've done a scope self-calibration once with an active probe in one channel, and, there was a DC offset error on my channel 1 until I redone the scope self-calibration. The self calibration was originally needed since the DC offset drifted out of alignment by around 0.3v over a year of use.
The DC offset would still show in AC coupled mode since this drift is after the DC probe filter in the scope electronics.
Steamer:
Calibration was done several times, and that didn't make a difference.
The problem isn't resolved yet. As far as I know Siglent is looking into it, I've opened a support case.
Emile
Steamer:
They replaced my faulty SDS1104X-E with a new one. (I only had it for about a week)
This one is working as expected. Thank you for the service Batronix/Siglent.
Emile
Navigation
[0] Message Index
[*] Previous page
Go to full version