Electronics > Beginners
Settings for 861DW rework station?
(1/1)
ryanmills:
Any guidance on the settings for a Quick 861DW? I heard around 200 for solder paste but I'm having to use it around 300 with the air speed at 40? I'm using MG Sn63/Pb37.
thinkfat:
I don't have the same hot air station, but on mine I usually go for 270-300 for leaded paste. No idea about the airflow, I set it so that no parts fly off the board.

Gesendet von meinem Nokia 6.1 mit Tapatalk

Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod