| Electronics > Beginners |
| Show output from a vU meter on a 10 Segment Led Bargraph |
| (1/1) |
| grant1842:
I am using this simple 555 timer circuit to measure ESR. Please see schematic attachments. It does a great job and shows great on the small vU meter. I would like to use a 10 Segment Led Bargraph https://tinyurl.com/y44sdudd to show the measurement. I would like to use and Arduino to look at the current/voltage and drive the Leds with it based on the current/voltage measurements. I know there is small current at the Meter. I all son know i will need to drive the LEDS with 3v> <5. I am not sure about an op amp or something to boost the signal or a different solution. Thanks for your help and guidance. |
| MarkF:
Here, I will let you pick your flavor. Couldn't be bothered to check the input voltage levels required. |
| Brumby:
What MarkF said. |
| grant1842:
Thanks for the info. I will look at those chips |
| Navigation |
| Message Index |