Electronics > Beginners

Single ended signal on PCB

(1/1)

Vcky_electro:
Hi,
I have designed board, in that due to board room limitation we cant achieve 50ohms impedance for single end signal. 60ohms is possible in that design, so what would happen if we use 60ohm impedance trace instead of 50ohm trace..

Regards,
Vicky

Raj:
you'll have to change your termination method, that's it

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod