Electronics > Beginners
Single-Wire EEPROM Implementation Problem (AT21CS11)
(1/1)
Sarcarean:
So I am banging my head against the keyboard now. I am trying to read a SWI EEPROM (AT21CS11) using PB7 of ATMEGA32U2. I have that line connected to VCC (3.3V) with a 2K  \$\Omega\$ resistor. I am not sure what the problem is, but I have noticed that the reset and discover event does not look correct.

The RESET and DISCOVER event should look like this: PB7_LOW, wait 200uS, PB7_Release, wait 10uS, PB7_LOW, wait 1uS and release, then check if bus is being pulled down by AT21.

Here is what the correct waveform looks like:


However, here is what mine looks like:


Does anyone have any ideas of what I did wrong?
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod