Electronics > Beginners

smd capacitor need so help under standing them for part look up!

(1/2) > >>

sub2001zero:
Hi everyone I need some help I working  on my friends Nintendo watch. The screen fade out after a few min after put a battery. I found out it need a smd output converter cap i don't if I am saying that right I found out with one it was and I desolderer  it from the board to take a read out. So this is where I need help I used a fluke 87v meter on ohm the smd read 8.- m ohm to 17.3 m ohm at the highest point is that right? I need help find a smd cap to replace it thanks!  :-DMM

Jwillis:
The resistance won't tell  much about the value of the capacitor. If you can borrow or find a multi meter that has a capacitance setting that would be much more helpful. If you can take a clear photo of the board  and where it came from that would also be helpful.Some here may be able to determine a ball park value based on the surrounding components.

sub2001zero:
so i need a lcr meter

schmitt trigger:
An LCR meter would be best, but many newer DMMs incorporate capacitance measurements too.

sub2001zero:
I also have a fluke 289 will that help. What lcr meter I don't want to spend more then 200.00 I was look at the  AT824 Digital LCR Meter or the  DE-5000. What is your thought on this!

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod