Electronics > Beginners
SMD Soldering practice kit instructions
<< < (4/4)
hamster_nz:
Top row (with black on the '-' pad.

R48 5V
R50 jumps around
R49 Jumps between 1.3V and 3.8V
C28 Jumps around.
C27 0V

Other ends
R48 Jumps betweem 1.3V and 3.8V
R50 Jumps around
R49 mostly around 2V
C38 around 3v3
C27 Around 2.5V (jumping)

555 pins

1 0V0
2 Jumps around (same as pin 6)
3 Jumps
4 5V0
5 3V3
6 Jumps around (same as pin 2)
7 Jumps around
u 5V0
hamster_nz:

--- Quote from: rthorntn on May 07, 2018, 09:21:25 am ---Thanks hamster_nz! Could you please post a picture of an entire soldered board so I can use it for reference?

--- End quote ---
See attached.


--- Quote ---I can get continuity on one side of R48 but not on the other side, should I be able to get continuity through a 10K ohm resistor?

--- End quote ---
A 10k is too high to pass a continuity test.

rthorntn:
Thanks, Pin 8 on the 555 wasn't connected well enough, I added a dab of solder and it works!
Navigation
Message Index
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod