Electronics > Beginners

Soldered 0805 vs 0603 vs 0402 vs 0201 vs 01005 vs 008004 today :)

<< < (3/14) > >>

Neganur:
I used to think 0201 was quite doable but that was before my eyes got bad :P almost everything has to happen under the microscope nowadays.

Anything smaller than that risks getting damaged by tweezers too easily imo! Rather just reflow that stuff.

timgiles:
Amazing. Not sure I could do that (hand solder) below 0402 - not even sure I could place those two smaller components and reflow it!

Gonna have to buy some of them to show my colleagues - they thought 0201 was crazy.

KL27x:
I wonder what the vacuum pickup needles look like for those things. The tweezers look gigantic.

Brumby:
At that size, almost anything can cause component movement problems.

Six molecules of condensed rosin vapour on the tip of the tweezers is enough to act like a blob of Blu-tack.  (Perhaps a slight over-exaggeration.)

Pedro147:

--- Quote from: Brumby on October 01, 2017, 02:42:10 am ---At that size, almost anything can cause component movement problems.

Six molecules of condensed rosin vapour on the tip of the tweezers is enough to act like a blob of Blu-tack.  (Perhaps a slight over-exaggeration.)

--- End quote ---
That's no exaggeration at all  |O

 SMD components sticking to the tweezers is the bane of my life.

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod