Electronics > Beginners
spdt switch
fixit7:
I should have shown this earlier.
https://www.dropbox.com/s/0dyg6wogy341lhd/KEEP_circuit.jpg?dl=0
I have a 3rd wire going from switch to the negative of the buzzer.
Richard Crowley:
Your photo shows a DOUBLE pole, double throw (DPDT) switch. But your circuit is using only one "pole". It is common to see double pole switches connected with the poles in parallel. That provides a rather more reliable action for small-signal applications like yours. I would strap the sections in parallel if you don't need double-pole operation. Old-school open slide switch designs like that are not necessarily reliable for very low power applications.
ebastler:
--- Quote from: Richard Crowley on May 22, 2019, 11:44:18 am ---Your photo shows a DOUBLE pole, double throw (DPDT) switch.
--- End quote ---
I see a SPDT switch, and a shadow.
fixit7:
--- Quote from: Richard Crowley on May 22, 2019, 11:44:18 am ---Your photo shows a DOUBLE pole, double throw (DPDT) switch. But your circuit is using only one "pole". It is common to see double pole switches connected with the poles in parallel. That provides a rather more reliable action for small-signal applications like yours. I would strap the sections in parallel if you don't need double-pole operation. Old-school open slide switch designs like that are not necessarily reliable for very low power applications.
--- End quote ---
I must need a double pole switch because when I substituted a spdt switch, the circuit stopped working correctly.
Richard Crowley:
--- Quote from: fixit7 on May 22, 2019, 03:12:03 pm ---I must need a double pole switch because when I substituted a spdt switch, the circuit stopped working correctly.
--- End quote ---
That makes no sense at all. Your circuit clearly shows a SINGLE pole, double throw switch.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version