| Electronics > Beginners |
| Square wave generation & current |
| << < (3/5) > >> |
| zanzeoo:
No more idea ? |
| T3sl4co1l:
What is the load actually? If it's literally a 33 ohm resistor, why not use DC? Tim |
| zanzeoo:
Yes its 33 ohms but i need 2Mhz freq... ??? |
| mikerj:
--- Quote from: zanzeoo on October 09, 2018, 12:39:06 pm ---Yes its 33 ohms but i need 2Mhz freq... ??? --- End quote --- Why do you need a differential output? Can a single ended drive be used (one side of the resistor be connected to 0v the other other side driven by 10Vpp)? |
| zanzeoo:
--- Quote from: mikerj on October 09, 2018, 04:18:16 pm --- --- Quote from: zanzeoo on October 09, 2018, 12:39:06 pm ---Yes its 33 ohms but i need 2Mhz freq... ??? --- End quote --- Why do you need a differential output? Can a single ended drive be used (one side of the resistor be connected to 0v the other other side driven by 10Vpp)? --- End quote --- Yes because it's suppose to simulate a sensor so , differential is needed . |
| Navigation |
| Message Index |
| Next page |
| Previous page |