Electronics > Beginners

Square wave generation & current

<< < (3/5) > >>

zanzeoo:
No more idea ?

T3sl4co1l:
What is the load actually?

If it's literally a 33 ohm resistor, why not use DC?

Tim

zanzeoo:
Yes its 33  ohms but i need 2Mhz freq...
 ???


mikerj:

--- Quote from: zanzeoo on October 09, 2018, 12:39:06 pm ---Yes its 33  ohms but i need 2Mhz freq...
 ???

--- End quote ---

Why do you need a differential output?  Can a single ended drive be used (one side of the resistor be connected to 0v the other other side driven by 10Vpp)?

zanzeoo:

--- Quote from: mikerj on October 09, 2018, 04:18:16 pm ---
--- Quote from: zanzeoo on October 09, 2018, 12:39:06 pm ---Yes its 33  ohms but i need 2Mhz freq...
 ???

--- End quote ---

Why do you need a differential output?  Can a single ended drive be used (one side of the resistor be connected to 0v the other other side driven by 10Vpp)?

--- End quote ---

Yes because it's suppose to simulate a sensor so , differential is needed .

Navigation

[0] Message Index

[#] Next page

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod