Electronics > Beginners

Standart Inverter Problem

(1/2) > >>

igorbog:
I have created simple inverter, but when I make trans. Simulation, It shows me Low output voltage. Do you have any idea?

amspire:
That inverter circuit is a logic inverter - it is not intended for analog.

One of two things could be happening.

1. Your FET models may be for a very small geometry FET and that is the best the Pchannel FET can do into 1K, or

2. The N-Channel FET is dominating and at that bias voltage, it is heavily on.  A check of the drain currents would show if this is occuring.

Richard

igorbog:
Thanks.
Tell me please where I can in Orcad change Pmos Channel width in order to make it simitery

amspire:
Can you plot the n-channel drain current first?

It may be very high.

igorbog:
attached

Navigation

[0] Message Index

[#] Next page

There was an error while thanking
Thanking...
Go to full version