Electronics > Beginners
Stuck with Python problem
(1/3) > >>
Muffins:
Hi Guys,

I'm trying to get ESP-Link onto an ESP12F. I'm a windows user and the process seems to favor users running linux and python.

I've been following the tutorial described on its github page:https://github.com/jeelabs/esp-link/blob/master/FLASHING.md

I get down to this point:
> git clone https://github.com/themadinventor/esptool.git
Cloning into 'esptool'...
remote: Counting objects: 268, done.
emote: Total 268 (delta 0), reused 0 (delta 0), pack-reused 268
Receiving objects: 100% (268/268), 99.66 KiB | 0 bytes/s, done.
Resolving deltas: 100% (142/142), done.
Checking connectivity... done.

(no problems up to this point)

> cd esptool

> python setup.py install

After which I get the error:
python: can't open file 'setup.py': [Errno 2] No such file or directory

However, the file is present in the directory! I have checked the path and it seems good. Admittedly I have run so far into the night on this one I barely know what I am doing. I've included an image in the attachments of my results.


tpowell1830:
try putting the full path in front of setup.py (C:\windows\system32\esptools\setup.py)
Muffins:
I just tried, it gives the same error.
tpowell1830:

--- Quote from: Muffins on May 19, 2018, 06:49:39 am ---I just tried, it gives the same error.

--- End quote ---

what version of python do you have installed?
filssavi:
I know it seems dumb but have you made shure that the command prompt working directory is the same that contains your installation file?
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod