Electronics > Beginners

Sweep function control for MHS5200A function generator using serial monitor

(1/1)

proppa:
Hi,

I have used these previous threads to attempt to control the function generator using serial monitor

However, there's no code on how to use sweep function for channel 2? I can only at the moment set channel 1. can anyone help?

https://www.eevblog.com/forum/testgear/mhs-5200a-serial-protocol-reverse-engineered/

Was wondering if someone can point me the right direction or have a solution.

Attached are the protocols.

Navigation

[0] Message Index

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod