Electronics > Beginners

T12 soldering station with alternative power supply

<< < (3/3)

bd139:
That's an interesting idea. I would do that if I was to approach this again  :-+

runaway:
Here is my case: https://www.eevblog.com/forum/beginners/hakko-t12-tips-starting-problem/?action=dlattach;attach=663441
Modded ATX 250W PSU, now it has negative 12 VDC amperage as high as positive 12 VDC, so both outputs are connected in series and give 24 V 13 A max. Twinned solder is needed to get relatively cheap and multipurpose soldering tweezers (single hand grip variant is still under construction). Both tips are grounded, full heating time is about 10 sec, all the PSU staff protections are in play.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod