| Electronics > Beginners |
| TL071 distortion - bad amplifier design? |
| << < (3/26) > >> |
| oPossum:
The voltage rating on the A1015 and C1815 is too low. You should have at least 100V Vceo devices for +/- 40 volt rails. The TIP41/42 must be the C versions (TIP41C, TIP42C). |
| Treehouseman:
--- Quote from: Bassman59 on December 10, 2018, 03:25:27 am --- --- Quote from: oPossum on December 10, 2018, 03:15:26 am ---The stage following the op-amp is inverting, so the feedback to the + input of the op-amp is correct. --- End quote --- no. --- End quote --- k |
| oPossum:
You should also have the Zobel network (10 ohm resistor + 100 nF capacitor) on the output to help with stability. |
| AngraMelo:
Like this? |
| oPossum:
--- Quote from: AngraMelo on December 10, 2018, 05:08:08 am ---Like this? --- End quote --- Yes |
| Navigation |
| Message Index |
| Next page |
| Previous page |