| Electronics > Beginners |
| TP4056 - thermal pad |
| (1/1) |
| papa_lazerous:
HI all, I have been working on a project that I am using a TP4056 to charge a single 18650 cell, and it all works except the TP4056 gets too hot and fails after some time, the reason is I didn't include a thermal pad in Kicad to take the heat away from the die my fault as I designed the board before I had the chip in front of me and used the wrong footprint. Now I am redesigning my board layout and will put a pad below the chip and some vias to get some of the heat away from the chip. I cannot find any information on what I should connect to the pad to electrically. I used a multimeter on continuity and the pad on the bottom of the chip is not connected to any of the pins on the chip. That said I was going to connect it to the GND plane as that is the largest copper fill I have on the board. I would be very appreciative of any advice on this, the link to the datasheet is below. However it leaves allot of information out imho https://dlnmh9ip6v2uc.cloudfront.net/datasheets/Prototyping/TP4056.pdf |
| mikerj:
The datasheet states "Available Radiator in 8-Lead SOP Package,the Radiator need connect GND or impending". "Impending" appears to be a bad translation, and might have meant "isolated" but it seems pretty clear that the pad can be safely connected to ground. |
| papa_lazerous:
Thanks I will connect it to GND, a second set of eyes definitely helped as I looked over the datasheet multiple times and glossed right over that bit |O |
| Navigation |
| Message Index |