EEVblog Electronics Community Forum

Electronics => Beginners => Topic started by: carleeno on May 27, 2020, 05:34:01 pm

Title: Trying to ID a connector
Post by: carleeno on May 27, 2020, 05:34:01 pm

Hi, my first post here, I apologize if I'm asking in the wrong place.

I'm trying to identify a connector on a BMS for the onewheel xr. I've attached a picture of the connector.

I've gone through mouser and digikey looking to figure out what it is, but no luck.

Here's what I know:
26 positions
2 rows
1.5 mm pitch
no markings visible without removing the connector (something I don't want to do yet)

The closest connector I found is the Molex CLIK-Mate, but it's not quite the same.

Anybody know what this is, or have any suggestions of how I can figure out what it is?

Thanks!

Title: Re: Trying to ID a connector
Post by: Jwillis on May 27, 2020, 09:44:20 pm

1.5 mm  ZPD connector .