Electronics > Beginners
Trying to recreate a open source schematic -- Need Help.
(1/2) > >>
redgear:
Hey all,

I am trying to recreate a open source motor controller project using Eagle CAD and I am facing few difficulties.

1) How do I calculate the value of the resistors R103,R104 and R6(is it 22 times of R0?) and shunts R54 and R53?

2) The schematic says R6 resistor is not placed, should I not include it while designing the Gerbers?





3) I am able to create labels with a pointed end on the right side but I am not able to get it to point double side or towards the left.




4) How do I differentiate between a bus and a wire?

Thank you!
Rerouter:
1. R103/104 are both 22.0 Ohms. R53/54 are 0.001 ohms. R6 would be a 0 ohm resistor or a solder bridge
2. R6 is an option. Add a footprint but you dont have to populate it.

The last 2 i am not sure about
redgear:
Thank you!
redgear:

--- Quote from: redgear on September 19, 2019, 06:09:56 am ---
3) I am able to create labels with a pointed end on the right side but I am not able to get it to point double side or towards the left.

(Attachment Link)


4) How do I differentiate between a bus and a wire?

Thank you!

--- End quote ---

Can someone help?
oPossum:
3 - Right click to rotate

4 - Busses are blue, nets are green
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod