Electronics > Beginners
UART Communication between GSM and GPS
(1/1)
Aankur:
UART Communication between GSM and GPS

I want to establish a UART Communication between GSM and GPS.
The Supply Voltage of GPS is 3.3V.
The Supply Voltage of GSM is 3.8V.

The measured RX/TX Voltage Levels of GPS is 2.8V and 0V (for logic High and logic Low).
The measured RX/TX Voltage Levels of GSM is 1.8V and 0V (for logic High and logic Low).

Since there is a difference between RX/TX logic levels of the GSM and GPS, So I am
not able to establish the UART Communication between GSM and GPS.

I am using the interpreter of the telit GSM module to process the data of the GPS.
I am not using any micro-controller to in between the GSM and GPS.

Please suggest me a possible way to perform voltage (or Logic) level shifting.
MadScientist:
A simple transistor circuit on the relevant Tx lines will do the job
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod