Electronics > Beginners
Unable to set channels to analyze UART in PulseView
(1/1)
anking:
I'm trying to analyze data coming from my Rigol DS1054Z using pulseview but unable to assign any channels to the decoder.

After I capture data from the scope it is being displayed on a screen as expected. Then i'm adding UART decoder that displays "no channels assigned"

when i try to assign channels manually I cannot select any from the drop-down list. what am i doing wrong here? :-//

Screenshot attached.
anking:
I found an answer(Thanks to L29Ah from #sigrok IRQ channel). I needed to digitize the channel first (Channel->conversion), once this was done I was able to connect it to the decoder.
However it seems like I can onle decode very short messages because the sample rate is mot high enough. Is this a hardware limitation of my scope(1GSa/s)? or is it because it is connected to PulseView via Ethernet?
TK:
Why not do the UART decoding on the Rigol DS1054Z itself?
Navigation
Message Index
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod