| Electronics > Beginners |
| Understanding gerber files - simple question |
| (1/3) > >> |
| FriedMule:
Hi I need someone to look at these gerber files, to tell me what the 4 layers is containing. I know the top layer and bottom layer but what about the two middle layers? https://github.com/dkramnik/Eagle-Public/raw/master/instrumentation-active-probe-makemit-2014/MakeMIT%202014%20Wk1/Active%20Probe%20Proto2.zip |
| chrisl:
Looks like it is a 2 layer board as I only see 2 layers; top and bottom. Other layers in the zip file are: - assy dwg - solder mask top - solder mask bottom - NC drill |
| Ysjoelfir:
The file endings of gerber files aren't fixed in any way, but I struggle a bit to make a sense of those you linked to. From looking at it it seems like the following: .plc: Silkscreen layer, plc = "placement"? .sol: bottom layer, sol = "solder"? .cmp: top layer, cmp = "component"? .stc: Solder Mask Top .sts: Solder Mask Bottom .drd: NC Drill I'm not sure about .stc and .sts. It definitely looks like the soldermask layer, but I wouldnt name it ".stx", since I would read it like "stencil component/solder", which could be the paste mask. |
| Siwastaja:
Yes, the naming can be anything. If the file names are not clear enough as they are, the contents must be specified separately, like using a human-readable text file. Lacking that, you need to reverse-engineer. Just look at the content with any gerber viewer: Has traces and pads in it -> is a copper layer Only has SMD pads in it, pads are slightly larger than the same pads in the copper layer -> is a solder mask layer Only has SMD pads in it, pads are slightly smaller than in the copper layer -> is a paste layer Isn't a gerber file at all, but includes X...Y... coordinates: is an Excellon drill file. |
| Ysjoelfir:
--- Quote from: Siwastaja on August 12, 2019, 06:26:03 am ---Just look at the content with any gerber viewer: Has traces and pads in it -> is a copper layer Only has SMD pads in it, pads are slightly larger than the same pads in the copper layer -> is a solder mask layer Only has SMD pads in it, pads are slightly smaller than in the copper layer -> is a paste layer Isn't a gerber file at all, but includes X...Y... coordinates: is an Excellon drill file. --- End quote --- That is pretty much what I did, thanks for writing down the little "tutorial" :) |
| Navigation |
| Message Index |
| Next page |