Electronics > Beginners
Update Firmwae
<< < (10/11) > >>
ataradov:
Send the new sniffer capture that captures both C & R  talking to each other and the update server trying to reach one of the devices.
ataradov:
Actually, if I remember correctly you had NWK_ENABLE_ROUTE_DISCOVERY disabled in your projects, but update server attempts to do the route discovery, which means it must be enabled there.

Your network configurations must be the same on all devices.
Peili:

--- Quote from: ataradov on April 01, 2019, 05:29:15 am ---Actually, if I remember correctly you had NWK_ENABLE_ROUTE_DISCOVERY disabled in your projects, but update server attempts to do the route discovery, which means it must be enabled there.

Your network configurations must be the same on all devices.

--- End quote ---
changed the configuration and recompiled the code.. now the response is attaching..
ataradov:
Well, it looks like your device started to receive the data, and then stopped. There is no way to tell what is wrong. Debug it.

It is probably stopped at the point where it saves the new image to the temporary location.
Peili:
When i try to upgrade,router stops sending data to coordinator. When i got error from OTAserver the router terminal shows "C".. But when i reconnect the router it will send data to coordinator . What is the issue?
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod