| Electronics > Beginners |
| USB 2 or USB 3 |
| << < (3/3) |
| Bratster:
it's kind of hard to tell from the poor quality of the first photo, but it looks like that connector has been bent down partially ripping it off the circuit board. Near the top you can see what looks like a crack in the circuit board where the connector mounting pin meets it, as well as on the bottom you can see that the mounting pin looks like it is torn out part of the through-hole plating along with it. It does look like there are pins soldered to all nine pads on the board with the super speed pins being broken in half. Need a higher quality photo to get any more info than that. As well as one from the side showing how bent the connector is. Sent from my Fi Moto x4 using Tapatalk |
| Navigation |
| Message Index |
| Previous page |