Electronics > Beginners
USB audio DAC, bluetooth reciver and shielded relays for tube amplifier
(1/2) > >>
WildMOSFET:
Guys, I'm designing a vacumm tube audio amplifier.
Configuration: push-pull ultralinear class B of EL34 8)

But I need some opinions :-//.

In addition to the analog line entry, I would also like to put a couple of modules:
1) DAC composed of USB input, analogue line output.
2) Bluetooth audio receiver, always with line out.

Can you recommend ready-made and tested modules?  :-BROKE
Can you also advise me on shielded relays for input selection? (old school method)  :-/O

Thanks for the attention  :-DMM

This is the 3D model of amplifier:
jmelson:
Hmm, monolithic ICs, vacuum tubes and RELAYS?  Gee, think you can fit a Diesel engine in there, too?  Just to make sure you have all the major technologies covered in one project. ;)

Jon
WildMOSFET:
I think I have all the skills needed to bring these different technologies together.  :-DMM
I just need to find these two modules.  :-//
Ah, I see the diesel engine well anyway.  :-DD

Probably the beginner section is not very suitable for this thread...
Audioguru:
Why are you designing an antique vacuum tubes amplifier that is 60 years old?
Where will you find the vacuum tubes and output transformers today?
floobydust:
You are better off asking your questions at the diyaudio.com forums.
There is support there for whatever technology or circuit you want to build and listen to.
Navigation
Message Index
Next page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod