Electronics > Beginners
Virtual ground push-pull
<< < (3/6) > >>
iMo:
Nope..
Zero999:
The oscillation isn't much of a surprise, as the load is capacitive. Increasing the ESR of the capacitors may help, at the expense of poorer transient response.

You could also try connecting and inductor with a resistor in parallel with it between the capacitors and feedback node. The circuit, consisting of the inductor and output capacitors, will have to be over or critically damped, otherwise it will ring and oscillate.
Kalvin:
Try tweking the 68 ohm resistor at the output a bit higher, like 100 - 150 ohms. Does it make things worse or better?
iMo:
@Zero999: the both caps had/have 20mOhm ESR (in all sims above and here).

iMo:
@Kalvin: 50ohm-1k step 50ohm, the bigger the worse.
Navigation
Message Index
Next page
Previous page
There was an error while thanking
Thanking...

Go to full version
Powered by SMFPacks Advanced Attachments Uploader Mod