Electronics > Beginners

Voltage Output 2V to 5V with 5K pot with 3.5V output in the middle

<< < (5/5)

Zero999:

--- Quote from: SeaMaster on June 30, 2022, 11:06:24 pm ---Thank you all for the replies. I'm not sure yet which one will be the best solution for this case. I will have to think about that and decide what should be implemented. The solution with OpAmp are simple, but can't drive much current. To be on the safe side, I would like the design to be able to drive about 1A of output current. 
Linear regulator will not work for that.
So I'm still quite not sure what will work....

--- End quote ---
You said in your other post it has an input impedance of 12k, which means the most it can draw is 417µA. Where did you get 1A from? I can tell you, it won't draw 1A from the 2V to 5V control voltage connection.

Navigation

[0] Message Index

[*] Previous page

There was an error while thanking
Thanking...
Go to full version