| Electronics > Beginners |
| Voltage reference not working properly #SOLVED# |
| << < (11/11) |
| iMo:
Is the -5V still -5V when -2.5V is pulled up to +0.99 or +0.77V?? PCB: your -2.5V is connected to the R29's wiper, isn't it? |
| FotatoPotato:
:palm: ....... Oh my lord I cannot believe this :-DD all this time spent, and I connected -2.5v to the damn wiper. SMH I'll go fix that and take a look at the results |
| FotatoPotato:
Hey presto, there you go Everything works now. I can't believe this was the issue... You guys saw the schematics, they were correct, but for some reason, the default Altium library switches pin 3 and the wiper |O..... For everyone who has pitched in on this post I want to say thank you so much, I really appreciate the help and it feels awesome to get so much help on this. Again, I can't thank you guys enough ;D |
| StillTrying:
:phew: I said it was the VR29 wiper on the previous page, :) although I didn't think it was going to be VR29 at all until you'd seen the -5V and +4.096V stable but the -2.5V still not. As I'm closing down all these data sheets, - the max. allowed -0.3V current in to the AD8660's inputs is 5mA. |
| iMo:
Therefore I would go with 33k resistor between OP277 output and AD8360 input :) |
| Navigation |
| Message Index |
| Previous page |